Small Clean Room Installation

Use the line drawing tool (ink bucket) to draw lines according to the CAD drawings

erect an outer arc with  a length of 2600mm

place the U groove on the drawn line,

and fix it with rivets.

According to the number marked on the drawing, start to build the D wall

Insert the panel into the U-groove

中 aluminum Install at the notch of the plate

Cut into 200-300mm 中 aluminum

After installation, install the glass window on the"中 aluminum"

The same method for the next panel installation

Pour the floor glue on the ground

And apply it evenly with a rubber shovel

and fix it with rivets.Finally, it will be cut into a 3000mm long and 2000mm wide PVC floor

Place it on the ground coated with glue

After the PVC floor is installed, start to install the inner arc

First install the plastic strip

The inner arc base is fixed on the plate with screws

Cut the finished inner arc base into small strips of 200-300mm

According to the actual needs, each interval is 600-800mm

Install the inner arc on the inner arc base

Use inner three general purpose glue to fix through the line

Install the pass box on the panel with hole

And use Angle aluminum and screw to fix it

Fix one end of the door frame in the air shower with screws

Install the door to the door frame

Use a glue gun to glue and seal the gap

Install the middle beam onto the plate

And fix it with a three piece set of screw rod and leveler