The main scope of application of the catalyst tablet press and precautions for use
Catalyst tablet press is mainly suitable for electronics, food, daily necessities, pharmaceuticals and other industrial sectors. The outer casing is fully enclosed, and the material is made of stainless steel, which meets the GMP standard. Equipped with a transparent observation window, you can clearly see the working conditions of the machine and can be fully opened, which is easy to see and maintain the inside. It has the characteristics of high pressure, large tablet pressing range, and can press ordinary, special-shaped, circular and other shapes of tablets, especially suitable for multi-variety and small-batch production. Mechanical and electrical integration, all controllers and adjustment devices are concentrated on one side of the body, easy to operate. Equipped with pressure overload protection device to avoid machine damage. The transmission mechanism with oil invasion lubrication is sealed under the body, prolonging the service life and avoiding cross-contamination. The punching die can be used in common with the tablet press machine. It can be used for pressing candy tablets, milk tablets, chewable tablets, buccal tablets, glucose tablets, etc. Precautions for the use of the catalyst tablet press: 1. Before the first use, read the instructions carefully against the actual machine before use. 2. The machine can only run in a certain direction (see the arrow on the hand wheel or the protective cover), and cannot be reversed to avoid damage to the machine parts. Special attention should be paid to the adjustment of tablet compression, and don't be negligent. 3. Belt tightness adjustment: adjust through two adjustment nuts on the electromechanical bottom plate. Be careful to lock it after adjustment. 4. When there is no power supply, press the tablet by hand, and the V-belt should be removed to reduce resistance and wear. But don't remove the big pulley too, because the big pulley also has the function of saving the effort of the flywheel. 5. When electric tablet pressing, the rotating handle on the hand wheel must be pulled down to avoid hurting people during operation. 6. Regardless of manual tablet pressing or electric tablet pressing, the upper punch rod should be in the rising position before starting and then start. If it is started when the upper punch is in the lowered position, it will enter the middle die pressing sheet just after starting. At this time, because the machine's speed has not gone up, the inertia is small, and it is easy to push the car. (That is, after the upper punch enters the middle mold, due to the resistance of the tablet,“top die”, so that the machine stops running, due to the heavy load when jacking up the car, it often damages the parts or burns the motor). 7. Treatment after jacking (1) When jacking occurs during electric tablet pressing, the power should be turned off immediately to avoid burning the motor. (2) When the jacking situation is relatively light, you can turn the handwheel with your hand to make the upper punch pass.“dead point”(However, it cannot be reversed, so as to avoid repeated feeding by the feeder, resulting in more serious jacking). (3) In the case of serious jacking, the small shaft of the upper punch must be removed to raise it to reduce the pressure, then turn the handwheel to eject the tablet, and then readjust the hardness of the tablet.